Runs the test.
Runs the test. The TAP stream will be written to Console.out and Console.err, so you can swap these out as required in order to parse it.
The exit code that the test produced. Success is indicated by 0,
failure to run the correct number of tests by 255, and any other
failure by the number of tests that failed. This should be used
by reporters which run a single test, which can call
sys.exit(exitCode)
Runs the test just like run, but in a way that makes sense when test results are being summarized rather than directly displayed.
Runs the test just like run, but in a way that makes sense when test results are being summarized rather than directly displayed.
Summarizing test reporters tend to repeatedly update the same line on the terminal, so this method makes calls to diag (which sends messages to stderr, where they are typically displayed as-is) prefix the message with a newline, to ensure that the output starts on its own line.
Base trait for test classes in this framework. Any tests that should be autodiscovered by
sbt test
should extend this trait, and implement runTests.